The Content Of The Article:

To replace a door that is too low, I have to remove its lintel in BA. I realized, above, a new lintel in BA and I can not remove the old.How to do? the old lintel measures 85 cm lg, 20 ht and 35 wide thanks GP

To deposit a reinforced concrete lintel, there are only two solutions: to release it on each side of the opening and to deposit it of a single block, or to destroy by chipping and / or mechanical cutting. Whether the lintel was cast in place or prefabricated, it is normally part of the masonry surrounding it, which makes it difficult to deposit it in a single block. It is anchored often enough the argement on both sides, from where the necessity to release it over all its length. Be careful not to destabilize the masonry!

On the same topic

  • DIY tips
    • Formwork and pouring of a lintel
    • Realization of a bay made of glass bricks: drilling

This may interest you


Video Instruction: How I install and make lintels (Mike Haduck)