- Energy to save
- The regulation
- The transmission of orders
Heating with electricity is no longer synonymous with discomfort or heavy energy consumption. This is actually the most efficient system in terms of regulation because each device can be controlled independently of others.
Choosing electricity for heating is freeing yourself from the constraints of a central heating system: flue pipes, storage of energy, distribution circuit, maintenance... you can forget all this and use electricity to heat you as simply as to light or cook. First of all, the cost of installation is much lower than all other heating systems.
To control your consumption, it is still essential to have good thermal insulation, but also a powerful programming system (even if the latter is true regardless of the energy you use).
The new generations of electric radiators make forget the poor results of the first generations. Less energy-hungry, equipped with programmable electronic thermostats, they regulate the temperature piece by piece to the nearest tenth of a degree.
New asset, they play the design card. Retro for renovation, refined in modern interiors: all styles are represented and all tastes are satisfied.
Energy to save
The consumption indicatorThis meter shows the consumption of electrical appliances and allows to know the cost of heating on the overall energy bill.
The relieverIt allows to optimize your electric subscription. The principle is to identify the non-priority circuits that can be cut in order not to exceed the power subscribed in the contract. Heating of a room, water heater, appliances... the circuits are cut according to their importance.
Programming consists of managing the temperature of the rooms as needed.
It allows heating to be programmed for 24 hours or 7 days, in "comfort", "economy" or "no frost" mode.
The regulation allows, whatever the climatic conditions, to maintain a constant temperature on a given setpoint.
The temperature of each room can be adjusted as desired.
|Living room, living room, office||19° C|
|Child's room||18 to 20° C|
|Entrance, clearance||18° C|
The transmission of orders
The regulation commands flow in two different ways from one radiator to another or from a programming station to the radiators.
Pilot wire regulationThis is an additional conductor (black) passed through the walls at the same time as the 230V power supply wires.
The pilot wire connects the radiators to the electrical panel, to each other, or to the control unit.
Electric radiator controlled from the painting
Electric heaters controlled between them from a master radiator
Online Power Line Control (PLC)The principle of the CPL is to circulate the information by the electrical wires which supply the 230 V devices.
The signal is transmitted on another frequency and at a different voltage. It does not disturb the general power supply.