The Content Of The Article:

The installation of a classic wallpaper requires several stages of preparation. When the patterns are shifted, we must also heal the identification between the strips.

to stick well his wallpaper

How to successfully apply the wallpaper?: first

How to successfully apply the wallpaper?: apply

How to successfully apply the wallpaper?: paper

How to successfully apply the wallpaper?: paper

How to successfully apply the wallpaper?: first

How to successfully apply the wallpaper?: successfully

How to successfully apply the wallpaper?: wallpaper

How to successfully apply the wallpaper?: first

How to successfully apply the wallpaper?: apply

How to successfully apply the wallpaper?: paper

How to successfully apply the wallpaper?: successfully

How to successfully apply the wallpaper?: apply

  • Draw on the wall a vertical on which will be aligned the first one.
  • Use a laser plotter, a plumb line or a spirit level.

  • Identify the direction of laying the paper.
  • Then cut the upper part of the first one after checking that the patterns will then connect correctly.

  • Measure the height of the ceiling up to the plinth and then postpone this measurement on the floor by adding about ten centimeters.
  • Cut with the cutter.

  • Present the second one against the first, aligning the patterns.
  • Find the exact length of the second one and cut it.

  • On the cutting table, turn the first piece over and apply the glue on the first half.
  • Make sure the glue layer is fine and even.

  • Slide the piece on the table and fold the fingertips with the fingertips.
  • Glue the second half and fold it in the same way.

  • Grasp the folded glue.
  • Apply this lé to the wall aligning perfectly with the vertical mark, and keeping a slight overhang on the ceiling.

  • Release the paper so that it unfolds and then rub down using the wallpaper brush.
  • Lift the paper and let it reposition itself if it deviates.

  • Marble the paper to the plinth.
  • Slide a cutting rule under the paper and then cut the part of the paper that is past the paper cutter.

  • Glue the back of the second lé then apply it on the wall against the first lining up the grounds.
  • An overhang of a few centimeters remains at the top.

  • Mark the angle between the ceiling and the wall with a knife to emerge, then carefully cut the paper over the cutter.

  • As long as the glue is cool, it is possible to slide the paper slightly on the wall to align the patterns and refine the fitting.
  • Marouflage to eliminate bubbles.


Video Instruction: How to hang wallpaper part 1: preparation