The Content Of The Article:

Install a wall sticker.

This type of installation is very simple, just follow the instructions of the manufacturer. The marking of stickers is always on a transparent transfer paper, which allows you to respect and visualize the position of the patterns. If you do not install your stickers immediately after their purchase, keep the boards flat, in a temperate place, out of the sun and as dry as possible.

All the images used were provided by the site acte-deco.fr

Install a wall sticker: transparency

Difficulty level:

Easy.

Necessary tools:

A squeegee or a metal ruler.
Scotch tape.
Scissors.

The preparation of the support.

The support on which you will put your sticker must be perfectly clean and dry before setting up the decor.
If you stick the sticker on a glass, it must be well degreased, for this it is advisable to use alcohol to burn.
During installation the support must be at a temperature between 10 and 20 degrees to optimize the bonding.
Do not proceed in full sun, as this promotes air bubbles between the wall and the sticker.

To pose small stickers.

Step 1: Prepare the sticker.

With the squeegee, rub on the transparency with a strong emphasis on the pattern.
Separate the transparency from the silicone paper by peeling it off.

Step 2: the installation of the sticker.

Install a wall sticker: transparency

Place the transparency on your support at the chosen location.

Install a wall sticker: sticker

Rub by pressing hard on the sticker with the squeegee from the center to the ends, while insisting on the grounds.

Install a wall sticker: sticker

Finally, lift the transparency by pulling it flat on the side and not towards you.

To pose big stickers.

Step 1: Prepare the sticker.

With the squeegee, scrub over the transparency with a strong emphasis on the pattern, but do not separate the transparency from the silicone paper.

Step 2: the installation of the sticker.

Place the sticker on the wall at the desired place, then put a piece of adhesive on one end of the sticker, then two other pieces of adhesive in the middle of the sticker at the top and bottom to fix it to the wall
Then separate half of the stickers (the one that is not fixed to the wall) of the silicone paper then cut the paper with scissors.
Glue this first half of transparency to the wall by passing the squeegee from the center to the edge.
Remove the adhesives then install the second half of the sticker by rubbing with the squeegee always starting from the middle.
Carefully peel off the transparent side and admire your work.

The wet pose.

For very large areas or on a window it is advisable to use this technique:
Remove the paper support and spray a little soapy water (a drop of dish soap for a liter of water) directly on the transparency.
Then apply the transparency directly to the wall or glass, then remove the water residue with the squeegee by rubbing on the sticker.
Let the transparency dry for at least an hour and then remove it carefully.


Video Instruction: Wall Decals: How To Apply a Wall Decal - Accent Studios Wall Decals