To connect a terrace terminal, it is first necessary to embed the ducts in the slab and to make the cable outlets at the precise location intended for the lighting.
Drill the holes at the cable exit location, then push in the dowels that will receive the mounting screws for the terminal board.
Turn the mounting plate over and screw on the terminal block bracket to make all electrical connections.
Run the cable through the turntable, then screw the mounting plate to the floor making sure to tighten the screws to prevent tearing of the terminal.
Connect one by one the wires of the power cable (phase, earth and neutral) making sure to screw them on the dominoes of the mobile terminal block.
Fit the cable clamp under the terminal block to slide the cable in, then tighten it with the two screws provided.
Insert the terminal cover on the mounting plate.
Screw the base of the terminal on the plate on either side of the cowling.
Screw a compact fluorescent bulb (E 14/11 W) on its base.
Close the cover on the diffuser by tightening the four screws with an Allen key.